Fire Fighting Operation; Fire-Extinguishing Bomb Work; Spraying Dry Powder Fire Extinguishing; End Of Flight - Walkera ZHUN Quick Start Manual

Walkera All Rights Reserved

14.0 Fire fighting operation

Tip: Before the operation, it is recommended to adjust the elevation angle of the launch tube to 4.5°.
Set the automatic obstacle avoidance safety distance in the WKDrone-ZHUN interface to 5 meters,
in order to hit the target more accurately, and turn on the auxiliary aiming laser switch to automatically
avoid the obstacle switch. Slide to the on position and the flight mode must be switched to GPS mode.
1. It is strictly forbidden to direct the laser to any human body, animal, vehicle, etc., and the
operator is legally responsible for the injury caused by this.
2. When using a laser-assisted sight indoors or at close range, wear a laser-shield of the appropriate
wavelength to avoid refraction, reflection, and direct light to the eye;
3. In public places where there are many people, in order to avoid accidental injury to others,
the use of lasers should be stopped.

14.1 Fire-extinguishing bomb work

5.00m 5.00m
14
15
5 m
3
4
1
When the aircraft flies to the target window
or 5 meters in front of the doorway, the
aircraft will automatically stop moving
forward, at which point you can manipulate
the direction rocker to aim at the target.

14.2 Spraying dry powder fire extinguishing

5.00m 5.00m
14
15
5 m
3
4
1
When the aircraft flies to the target window
or 5 meters in front of the door, the aircraft
will automatically stop moving forward, at
which point you can manipulate the direction
rocker to illuminate the auxiliary aiming
laser at the target point.
15.0 End flight
1). Manual Landing, AUTO Landing or Return to Home function landing or low voltage landing.
2). After landing, the laser auxiliary sight should be turned off and the nozzle should be put away. Then remove the head cover and
disconnect the power of the aircraft (pull out the power plug), release the battery binding strap and remove the flight battery from
the aircraft.
3). Finally, turn off the power of the remote controller.
5.00m 5.00m
Spray
Upgrade port
14
15
5 m
3
4
2
After aiming at the target, slide the
automatic obstacle avoidance switch to
the closed position in the WKDrone-ZHUN
interface.
5.00m 5.00m
14
15
5 m
3
4
2
After aiming at the target, slide the
automatic obstacle avoidance switch to
the closed position in the WKDrone-ZHUN
interface.
ZHUN
Charge Port
15V 4A
3
Double-click the "
status indicator of fire extinguisher status
will red light.the fire extinguisher will fly
to the target,after 5 seconds of reaching
the target room, the dry powder will be
automatically sprayed to extinguish the fire.
3
Double-click the "
the spraying dry powder. the status
indicator of fire extinguisher status will
green light after the fire has been successfully
extinguished, double-click the "
again to turn off the spraying.
Quick Start Guide
Extinguisher
" button and the
Extinguisher
Spray
Upgrade port
" button to turn on
Spray
" button
Spray
21
Charge
15V