Line Power Requirements - Keysight N4376D Getting Started

WA R N I N G

Line power requirements

C A U T I O N
Keysight N4376D Lightwave Component Analyzer, Getting Started
Please pay attention to the following laser safety warnings:
• Under no circumstances look into the end of an optical cable
attached to the optical output when the device is operational.
The laser radiation can seriously damage your eyesight.
• Do not enable the laser when there is no fiber attached to the
optical output connector.
• The laser is enabled by the software or by pressing the laser
switch on the front panel. The laser is on when the green LED
above the switch is lit.
• The use of the instruments, such as microscopes or spectacles,
with this product will increase the hazard to your eyes.
• The laser module has built-in safety circuitry which will disable
the optical output in the case of a fault condition.
• Refer servicing only to qualified and authorized personnel.
The Keysight N4376
D
with overvoltage category II and can operate from the single-phase
AC power source that supplies between 100 V and 240 V at a
frequency in the range 50 to 60 Hz. The maximum power
consumption of the optical test set is 40 VA with all options
installed.
Please refer to the documentation for your network analyzer for
information on its line power requirements.
Line power connectors
In accordance with international safety standards, the
instrument has a three- wire power cable. When connected to
an appropriate AC power receptacle, this cable earths the
instrument cabinet. The type of power cable shipped with
each instrument depends on the country of destination.
Please refer to the User's Guide for the part numbers of
available power cables.
Lightwave Component Analyzer complies
Introduction
11