Data Master; Parts Supplied - Raymarine e7D Installation And Operation Handbook

3.9 Data master

Any system containing more than one networked multifunction
display must have a designated data master.
The data master is the display which serves as a primary source
of data for all displays, it also handles all external sources of
information. For example the displays may require heading
information from the autopilot and GPS systems, usually received
through a SeaTalk ng or NMEA connection. The data master is the
display to which the SeaTalk, NMEA and any other data connections
are made, it then bridges the data to the SeaTalk
any compatible repeat displays. Information shared by the data
master includes:
• Cartography
• Routes and waypoints
• Radar
• Sonar
• Data received from the autopilot, instruments, the engine and
other external sources.
Your system may be wired for redundancy with data connections
made to repeat displays. However these connections will only
become active in the event of a fault and/or reassignment of the

data master.

28

3.10 Parts supplied

The parts shown below are supplied with the e7 / e7D multifunction
display.
hs network and
1. Sun cover.
2. Front bezel.
3. Multifunction display.
4. Rear bezel (required for trunnion bracket mounting).
5. Gasket (required for flush mounting).
6. Screw pack, includes:
• 4 x rear bezel fixing screws.
• 4 x unit mounting screws (for flush mounting).
• 4 x unit mounting screws (for trunnion bracket mounting).
7. Documentation pack, includes:
• Multilingual CD.
• Mounting and getting started multilingual guide
• Mounting template.
• Warranty policy
8. 1.5 m (4.9 ft) power and data cable.
9. Trunnion bracket.
3
2
1
9
8
e7 / e7D / e95 / e97 / e125 / e127 / c95 / c97 / c125 / c127
5
4
6
7
D12170-2