Windows Nt Firmware Power-Up Test Displays - Digital Equipment DECpc AXP 150 User Information

Windows NT Firmware Power-Up Test Displays

Windows NT Firmware Power-Up Test Displays
This section describes how to recognize when power-up tests pass
Summary
or fail in the Windows NT firmware. It also describes what to
do if the system fails the power-up tests.
Power-Up The power-up test display indicates tests that pass with the word
Test Display passed . It indicates tests that fail with the word failed and an
Differences error code
After the system passes the power-up tests, it displays the
following message:
System power up OK.
After the system fails the power-up tests, it displays the
following message, then halts in the OpenVMS and OSF/1
console:
System power up tests detected error(s).
See your system documentation for more information.
If the System If the system passes the power-up tests, it either boots Windows
Passes NT or halts in the Windows NT firmware Boot menu, depending
on the system default settings.
Table 2–7 describes the steps that you must follow after the
If the System
Fails system fails the power-up tests.
Table 2–7 Power-Up Test Failure Procedure
Step
1
2
2–10 Using the System
.
Action
If the system fails the power-up tests, turn the system
unit off, wait approximately 15 seconds, then turn it
back on again.
If the system continues to fail the power-up tests,
see the Customer Technical Information manual for
information on troubleshooting the system, running
diagnostics, and contacting your Digital service
representative.