Figure 3-5 Installing The 3.5 Inch Brackets - Digital Equipment MicroVAX 3100 88 User Information

To install the brackets on a 3.5-inch device, refer to Figure 3-5 and follow these steps:
1. Align the device as shown in Figure 3-5 with the internal cable connectors
away from you. The SCSI connector should be oriented at the rear of the assembly.
2. Attach the brackets to the device using the four screws provided.

Figure 3-5 Installing the 3.5 Inch Brackets

To install either 3.5-inch optional drives (with mounting bracket attached), or 5.25-inch
devices in the front drive bay, follow these steps.
1. Turn off the system, unplug the power cord and remove the cover.
2. Set the SCSI drive device jumpers or switches for the desired SCSI ID (address). This
address depends on the unit numbers currently in use. (See Appendix F, Setting SCSI
IDs, for a list of typical SCSI ID assignments. Appendix G, Equipment Log, contains
space to record your systems SCSI ID assignments.) Follow the guidelines in the
manual that came with the drive.
3. Remove the enclosure front bezel by pushing on the inside tab and lifting it up and
away from the front of the enclosure as shown in Figure 3-6.
Installing Hardware Options
1
MicroVAX 3100 Models 88/98 User Information 3-9
c
facing
MLO-013520