Standby Mode; Recording And Playback Of Programs - TrekStor SatCorder Neptune Operating Instructions Manual

4.8 Standby Mode

If you are not using your SatCorder, you can reduce the power consumption by placing it in standby mode.
Standby mode lets you reactivate it quickly. In standby mode, a display of the current time appears on the
display of your SatCorder. Programmed recordings are carried out when the SatCorder is in standby mode.
Please note: To switch off the SatCorder completely and prevent unnecessary power consumption, please
turn off your SatCorder using the mains switch on the back side. Please observe that no programmed recordings
can be carried out while the mains switch is set to "

4.9 Recording and Playback of Programs

Connecting a USB 2.0 Mass Storage Device
Your SatCorder has a USB 2.0 port on the back side. You can connect an external USB 2.0 hard disk
(e.g. a TrekStor DataStation) or a USB stick.
If you connect a suitable USB 2.0 mass storage device, a message appears during the initialization of the
storage device and once it has been successfully recognized. With a connected external USB 2.0 hard
disk, you can use the versatile recording and playback functions of your SatCorder optimally. For this
reason, the following assumes that an external USB 2.0 hard disk is being used for recordings.
Please note: The file system of the external USB 2.0 hard disk must be FAT32.
Please note: Please always unmount your USB 2.0 mass storage device prior to removing it. This is done by
pressing the yellow function key on your remote control.
Time Shift
If you want to interrupt a television program in progress, just press the Q key on your remote control.
The SatCorder immediately starts to record the program in progress on the connected USB 2.0 hard disk.
A freeze frame of the moment in which you interrupted the program and the time shift counter appear
on the screen. To continue the playback at the position at which you stopped, press the Q key again.
Instant Replay
If you press the V key of the remote control, the last 30 seconds of the playback of a time shift
recording in progress is repeated. If you activate the "i
the V key also works during the normal playback of the television program as soon as the selected
channel has been running for at least 30 seconds.
Record
With your SatCorder, you can record the current program as well as programming timed recordings
by pressing the O key.
If you want to record the current program, you have two possibilities:
• Endless recording: Start the recording by pressing the
recording, press the P key.
• Recording with automatic ending: When the information display is visible, the end time of the
current program is set according to the data given in the EPG.
EN If you want to plan your recordings in advance, you can use the EPG or Personal Planner for this purpose.
".
oFF
r " function in the "pVr S
nStant eplay
O key on the remote control. To stop the
– 46 –
" menu,
ettingS