Controls And Connections; Controls On The Front Side Of The Trekstor Satcorder Neptune Full-Hd 1080I; Connections On The Rear Side Of The Trekstor Satcorder Neptune Full-Hd 1080I - TrekStor SatCorder Neptune Operating Instructions Manual

1 Controls and Connections

1.1 Controls on the Front Side of the TrekStor
1
1) Standby key: Switches between operation and standby mode.
2) Dot-matrix VFD: Displays the set channel or further information during operation. The current time
is displayed in standby mode.
3) Program change keys: With these keys, switch to the next or previous channel on the current channel list.
4) Common Interface: Two slots for a Conditional Access Module (CI-CAM) for smartcards of pay
TV and other encrypted channels.
1.2 Connections on the Rear Side of the TrekStor
6
1) LNB Loop through: Output port for connecting an additional satellite receiver.
2) LNB In: Input for the cable of your satellite antenna.
3) Audio L/R: Stereo audio output.
4) Composite video output: Video output for television or video recorder. This output only supports
SD (i.e. Standard Definition) signals.
5) Mains cable
6) VCR SCART port: For video recorders.
EN
7) TV SCART port: For SD televisions.
8) Digital audio/video port (HDMI out): For the connection of an HD television.
9) USB port: Connect a USB 2.0 mass storage device (e.g. an external hard disk or USB stick) to this port
in order to use the USB-PVR functionality of your SatCorder.
10) Component video output: For the analog component input of your television. These connections
support HD signals.
11) S/PDIF - coaxial (top) and optical: Connect these outputs with a surround-sound-capable amplifier
or television.
12) On/Off switch: With this switch, you can disconnect your SatCorder from the power mains.
2 3
1 2
7 8
– 34 –
SatCorder neptune Full-HD 1080i
SatCorder neptune Full-HD 1080i
3 4
9 10
4
5
11 12