Satellite Settings - TrekStor SatCorder Neptune Operating Instructions Manual

• Motor System
If you have connected a motorized satellite antenna to your SatCorder, please use this option
("m ") to set which signals are sent to the motor.
OtOrized
Motorized Dish
If you have selected one of the options for a motorized satellite antenna and pressed the yellow function
key on your remote control, a new menu opens. Here you can set and adjust the position of a satellite.
You can use the bar displays for this purpose. Use the colored keys on your remote control to move
the satellite antenna and define the limits. The functions of the individual keys are shown at the
bottom of the screen.
Using the yellow "r
ecalculate
of the satellite antenna has changed. If you move the satellite antenna, just set the position of one
satellite and then press the yellow function key. Your SatCorder will then automatically calculate
the right positions for all other satellites.
• Satellite
Here you can select the satellite whose position you want to set.
• Reference Transponder
Here you can set which transponder is used as the reference.
• Move Dish
With this option, you can set the movement speed of the satellite antenna to "f
• Limits
Here you can turn the set limits on or off.
•

Satellite settings

Under this menu item, you can add satellites to the satellite list, delete them, or, if you use a motorized
satellite antenna, set the motor position of the individual satellites. For this purpose, use the keys of
your remote control shown at the bottom of the screen.
• LOF Low and High Band
Using this option, you can set the upper ("u
your LNB. The LOF (l
documentation of your LNB.
• Band Switching
Your SatCorder uses a 22kHz signal to change the frequency band of the LNB. If you are not sure
whether your LNB supports this function, set this option to "a
• Primary and Secondary DiSEqC
You can connect up to two cascadable DiSEqC switches to your SatCorder. With this option, you
can set the "t " and "i
ype
• Channel ID (Unicable Only)
In a typical Unicable LNB installation, you can connect several receivers to a single LNB if each connected
receiver has its own Unicable channel ID. Under this menu item, you can set the Unicable channel
ID of your SatCorder.
• LNB Feed (Unicable Monoblock LNB Only)
With this option, you can set which "lnb f
" key, you can recalculate all satellite positions when the basic position
O f
Ocal ScillatOr requency
" for the DiSEqC switch.
nput
" of a Unicable Monoblock LNB of the SatCorder should be used.
eed
lOf") and lower ("l
pper
) of the LNB can be found on the LNB itself or in the
utO
– 41 –
" or "c
ine
lOf") frequency band of
Ower
".
".
OarSe
EN