Connect The Module To The Easykey; Cabling Connections - Graco 15V963 Instructions Manual

Connect the Module to the
EasyKey
F . 1 is only a guide showing installation of the Graco
IG
Gateway in a ProMix 2KS System; it is not a complete
system design, Contact your Graco distributor for assis-
tance in designing a system to suit your particular
needs.
1. Shut off ProMix 2KS power (0 position). F
shut off power at main circuit breaker.
F . 2: Power Off
IG
2. Connect a 2-wire twisted pair cable with shield wire
from the EasyKey connector to the connector on the
Gateway module. Connect a communications
wire/cable (protocol dependent) from the Gateway
module to the PLC. See F
NOTE: Graco provides expansion cards for DeviceNet
and Profibus protocols. DeviceNet setup procedures are
on page 42. Profibus setup procedures are on page 57.
See page 40 for Parts.
NOTE: If using the Graco Gateway in your system, dis-
connect its cable from the EasyKey before updating the
ProMix 2KS software.

Cabling Connections

See F . 4 and F . 5 for typical cable connections in a
IG IG
ProMix 2KS system.
F . 6 through F . 9 show other possible cable connec-
IG IG
tions.
312785B
. 2. Also
IG
0 = OFF
TI12657a
. 3.
IG
Install the Gateway Module Hardware
7