Load the Software
1. Connect the USB cable (23, supplied) between the
USB port on the Gateway module and a USB port
on your PC. See F
IG
USB Port
USB Cable Strain Relief
F
. 12: Gateway Module USB Port
IG
2. F
. 13 will appear. Select "Yes, this time only", then
IG
click Next.
F
. 13: Found New Hardware Screen
IG
312785B
. 12.
TI12930a
3. F
. 14 will appear. Insert the CD in your PC's
IG
CDROM drive. Select "Install the software from a list
or specific location", then click Next. The program
location is C:\Program Files\Graco\GracoCon-
fig\Device.
NOTE: The name of the driver may be different. Just
accept the name and proceed by following the
instructions on the screen.
F
. 14: Load Software from a Specific Location
IG
Software Updates
Contact your distributor or Graco Technical Assistance
for software updates.
Install the GracoConfig Software
13