Page 1
Instructions 15H885 Ethernet Upgrade Kit 311612 rev.A Allows a computer to communicate with the Graco Variable Frequency Drive (VFD). Important Safety Instructions Read all warnings and instructions in this manual and in Variable Frequency Drive manual 311596. Save these instructions.
Page 2
Installation and Operation Installation and Operation For a Fixed IP address: a. Default IP address is 192.168.1.100. If default IP address is acceptable, navigate to Pr MM.00 (Pr 16.00 if installed in slot 2), set its value to 1000, and press the red Stop/Reset switch to save the default address, which will allow the Ethernet module to use it at every power-up.
Page 3
Graco uses a Visual Basic program to display the run screen on the computer. This software and program is not supported by Graco.
Page 4
With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.