Configure The Rsnetworx For Devicenet Software - Graco 15V963 Instructions Manual

™
Appendix A: DeviceNet Slave Communication

Configure the RSNetWorx for DeviceNet Software

RSNetWorx for DeviceNet is used to set up and manage
a DeviceNet network. To begin the configuration, launch
RSNetWorx for DeviceNet from your development PC.
Start a new network by selecting: File>New>DeviceNet
Configuration.
Register the EDS file generated by Gateway as shown
in the previous section of this document by selecting:
Tools>EDS Wizard>Register an EDS file(s).
F . 38: Register the EDS File
IG
Select Register a single file, and browse to the location
where you saved the Gateway.EDS file.
F . 39: Browse to Graco Gateway EDS File
IG
52
Make sure that the .EDS file validation is successful.
F . 40: EDS Validation
IG
If desired, select a new image file to represent the Gate-
way.
F . 41: EDS Image File
IG
312785B