Conversion Of Valve Location For Controlling One Or Two Solenoid Coils - Festo CPA10-VI Manual

5. Maintenance and conversion

5.5.4 Conversion of valve location for controlling one or two solenoid coils

Components
manifold sub−base for controlling one solenoid coil
or
manifold sub−base for controlling two solenoid coils
Tab. 5/6: Manifold sub−base
1
EV1:
Manifold
sub−base for
controlling one
solenoid coil
EV2:
Manifold
sub−base for
controlling two
solenoid coils
Fig. 5/11: Identifying the manifold sub−bases
Festo P.BE−CPA−EN en 0306d
The manifold sub−base determines the valves which can be
fitted on a valve location (with one or two solenoid coils).
In order that a valve location can support one or two solenoid
coils, you must replace the manifold on the relevant sub−
base.
For conversion you will require:
By means of the identification on the manifold sub−base (see
diagram), you can ascertain the manifold sub−bases with
which your CPA valve terminal is equipped.
Ô Ô Ô Ô
Ô Ô Ô Ô Ô Ô Ô Ô
Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô
Ô Ô Ô Ô Ô Ô Ô Ô Ô
Ô Ô Ô
Ô Ô Ô Ô
Ô Ô Ô Ô Ô Ô Ô Ô
Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô
Ô Ô Ô
Ô Ô Ô Ô
Type
CPA..−EV1
CPA..−EV2
1
5−25