Festo CPA10-VI Manual page 103

5. Maintenance and conversion
1
CPA valve
terminal with MP,
CP, AS−interface
connection or
CPX terminal
2
CPA valve
terminal with IC
connection
Fig. 5/3: Loosening components on sub−bases
Festo P.BE−CPA−EN en 0306d
4. Loosen the fastening screws of all components on all sub−
bases by approximately 2 turns. In this way you will avoid
distorting the CPA valve terminal as soon as you loosen
the tie rods (see diagram).
1
Ô Ô Ô
Ô Ô Ô
Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô
5. Replacing a sub−base or a manifold sub−base
Remove the components on the sub−base to be replaced
(see this chapter, Replacing valve plates, blanking plates
or additonal pressure supply plates").
2
Ô Ô Ô Ô Ô
Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô
Ô Ô Ô Ô Ô
Ô Ô Ô Ô Ô Ô Ô Ô Ô Ô
Ô Ô Ô Ô Ô Ô Ô
5−13