Henny Penny EVOLUTION ELITE Series Operator's Manual page 73

C C h h a a p p t t e e r r 5 5 P P r r o o d d u u c c t t P P r r o o g g r r a a m m
M M o o d d e e
This mode allows you to program the following:
• Change Product Name
• Assign Button
• Change Times & Temp
• Change Cook ID
• Alarms
• Quality Timers
• Include in Filter Count (Global)
• Filter at X no. of loads (Mixed)
• Load Compensation
• Load Compensation Reference
• Full Heat
• PC Factor
5 5 . . 1 1 M M o o d d i i f f y y i i n n g g P P r r o o d d u u c c t t S S e e t t t t i i n n g g s s
Press and hold the program button
1 1 ) )
followed by "ENTER CODE".
Enter code 1, 2, 3 (first 3 product buttons). "PRODUCT" and "PROGRAM" show
2 2 ) )
in the displays, followed by "SELECT PRODUCT' and "-P 1-" (ex: NUG).
C C h h a a n n g g e e P P r r o o d d u u c c t t N N a a m m e e s s
Use the up and down buttons to scroll through the 40 products, or press the
3 3 ) )
desired product button.
Press the right arrow button and "NAME" shows in the left display and the
4 4 ) )
product (ex: NUGGETS) shows in the right display.
Press "✓" button and the first letter in the name flashes. Press a product button
5 5 ) )
and the flashing letter changes to the first letter under the product button that
was pressed. For example, if product button one
letter changes to an "A". Press the same button again and the flashing letter
changes to a "B". Press it again and flashing letter changes to a "C". Once the
desired letter shows in display, press the right arrow button to continue to next
letter and repeat the procedure. Press and hold the right "X" button to exit
Program Mode, or press the right arrow button to continue on to "COOK TIME".
A A s s s s i i g g n n B B u u t t t t o o n n
until "PROG" shows in the display,
is pressed, the flashing
63