IDTECK iTDC EIO8 Quick Installation Manual page 14

※ iTDC Quick Installation Guide
In the 'Board List', MAC address of TCP /IP Module is displayed.
4) Check MAC address of TCP/IP Module (described on TCP/IP module) and then select it. Setting
information is displayed as below.
5) Select 'Network' tab.
Input network information of selected TCP/IP module to 'Local IP', 'Subnet', and 'Gateway'.
Network information can be assigned from network manager.
Input '5000' for 'Port', '0.0.0.0' for 'Server IP'(default), '0' for 'Server IP Port'. Select 'Server Mode' for
'Network Mode'. Refer to table below.
Column Name
Local IP
Gateway
Subnet Mask
Port (above)
Server IP
Port (below)
6) Select 'Serial' tab.
Select serial communication setting value ('Speed', 'Data Bit', 'Parity', 'Stop Bit', 'Flow') of selected
TCP/IP module.
Select '9600' for 'Speed', '8' for 'Data Bit', 'None' for 'Parity' '1' for 'Stop Bit' 'CTS/RTS' for 'Flow'. Refer
to table below.
The IP address assigned from corresponding network (Not duplicated)
The Gateway assigned from corresponding network (Not duplicated)
The Subnet Mask assigned from corresponding network (Not duplicated)
Mode
Setting Value
5000
0.0.0.0
0
Server Mode
14
Mar.11.2010