Cartridge Replacement - Inta Nulo CB10032CP Installation And Maintenance Instructions Manual

Cartridge Replacement

• Isolate both the hot and cold water supplies
• Remove the cover cap (2), the retaining screw (3), spring washer (4), brass spacer (5),
temperature control knob (6), the control knob bush (8) and the temperature stop ring (10)
paying attention to the position before removal.
• Remove the cartridge housing clip (9).
• Using a suitably sized spanner unscrew the cartridge (11) from the shower valve body.
• Replace with a new cartridge, the shower valve must be re-calibrated after fitting the new
cartridge following the procedure on page 7.
• Re-assemble the control knob assembly in the reverse order.
• Re-check the calibration temperature from the shower valve outlet.
Aftercare
Inta shower mixing valves have a high quality finish and should be treated with care.
An occasional wipe with a mild washing-up liquid on a soft damp cloth followed by a
thorough rinsing is all that is required.
The nozzles in the hand set or overhead soaker should be cleaned periodically to remove any
build up of debris or deposits which may affect the performance of the shower.
Do not use an abrasive or chemical household cleaner as this may cause damage.
Servicing
The Inta shower valve is designed to provide a high level of thermal performance to ensure the
life cycle is as long as possible;
Valves should be serviced annually which should include the following:
1 Cleaning the independent inlet strainers - the filter element.
2 Cleaning the thermostatic cartridge filters - the complete cartridge must be removed for
cleaning.
Spares
A full range of spares are available for this product.
PLEASE NOTE: Only genuine spares should be used.
© Intatec Ltd 2017
8