Programming Of The Telephone; Advanced Programming (Telephone Functions); Menu 1; Changing The Ringtone Melody - golmar T-540 PLUS SE User Manual

T-540 PLUS SE TELEPHONE
PROGRAMMING THE TELEPHONES
Description of the SW1 DIP switch:
The SW1 DIP switch is located in the central part of the circuit, accessible
by opening the telephone.
It enables the telephone to be configured as master/slave and an address
to be assigned to it.
Important: This type of programming cannot be performed on a general entrance door panel.
Switch number:
Value when ON:
*Factory setting
Advanced programming of T540 Plus SE telephones:
Advanced programming enables the telephone's default settings to be changed:
Menu 1:
Then adjust the settings as required:
-

Changing the ringtone melody:

The telephone has different ringtones to identify the origin of the call. The melodies assigned by default to the
ringtones can be selected from among others available on the telephone.
Select the ringtone to be changed: Each press on button
blinks (1 to 4 blinks) of the status LED and in the following order: door panel, guard unit, intercom call
and HZ apartment interior door call. When the final selection is reached, the following press returns "
the user to the first selection and the status LED blinks once (carousel mode).
Then select the melody for the ringtone (selected in the previous step) by pressing button
required carousel mode melody is heard.
- Activating / deactivating the doctor mode function: Doctor mode not activated (default setting).
The doctor mode function enables the door release to be activated automatically 5 seconds after making a call from " "
the door panel without having to establish communication or press door release button
seconds and the channel is free.
(Only the master telephone should be configured with doctor mode ).
To activate doctor mode: Press button
is activated or with 1 blink that the function is deactivated.
DIP 1 and DIP 2: Configure the telephone as master/slave. DIP 1 and DIP 2 to OFF master,
DIP 1 to OFF and DIP 2 to ON slave 1, DIP 1 to ON and DIP 2 to OFF slave 2, DIP 1 and
DIP 2 to ON slave 3.
DIP 3 to DIP 10: To configure the telephone address.
The switches set to OFF have a zero value.
The values of the switches set to ON are shown in the table below.
The telephone code is the sum of the values of the switches set to ON.
3 4 5
128 64 32
Switch off the telephone to be programmed.
Once switched off, press button
programming, the telephone will emit a number of tones and the LED will illuminate
orange.
"
" "
6 7 8 9 10
16 8 4 2 1
for 3 seconds to enter "Menu 1" of advanced
"
, and the status LED will indicate with 2 blinks that the function
Example: 0+ 64+0+16+0+4+2+1=87
selects a ringtone which is indicated with
. The call ends after 20
"
8
SW1
until the
Continued overleaf