golmar T-540 PLUS SE User Manual page 7

T-540 PLUS SE TELEPHONE
PROGRAMMING THE TELEPHONES
Programming T-540 Plus SE telephones:
Locate the SW2 DIP switch situated on the top left-hand side of the back of the EL632/PLUS module and
set number 2 to ON. The door panel will reproduce a sound to advise that the system has entered into
programming mode.
In systems with more than one door panel, only perform this procedure on the main door panel of each
building.
Important: To perform this programming, the telephone's SW1 DIP switch should be set to
M
S
SI
Each apartment must only have one master unit; if there are parallel units, either telephones or monitors, they must be
configured as slaves.
Make a call to check that the telephone has been successfully programmed. Programme the other
telephones in the same way.
Once the programming has finished, set the programming switch to OFF. If this is not done, the door panel
will emit tones to indicate that the system is still in programming mode.
Switch off the telephone to be programmed.
Once switched off, press the door release button.
While keeping the door release button pressed, switch on the telephone.
To show that the system is ready for programming, the door panel and the
telephone handset will emit a number of tones (the LED on the telephone will
illuminate red), enabling the door release button to be released. To establish
audio communication with the door panel, lift the handset.
Press the button of the door panel that will call this telephone.
At this moment, the door panel and handset will emit a number of tones (the
LED on the telephone will blink red).
To programme the telephone as
LED will illuminate red).
To programme it as
blink (green) once. Continue successively to
four times, and the status LED will blink (green) four times.
To programme the telephone as
will blink (green) once. Then press button
LED will illuminate red).
, press button
Master
Slave 1 , press button
Slave + Intercom
OFF .
for 3 seconds (the telephone's
once, and the status LED will
Slave 4 , pressing button
, press button and the LED
for 3 seconds (the telephone's
7