Fingerprint Reader Board - HP EliteBook x360 1030 G4 Maintenance And Service Manual

Fingerprint reader board

Table 5-5 Fingerprint reader board description and part number
Description
Fingerprint reader board (includes cable)
NOTE: The fingerprint reader board cable is also available in the Cable Kit, spare part number
L70755-001. The fingerprint reader bracket is available in the Hardware Kit, spare part number
L70758-001.
Before removing the fingerprint reader board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the fingerprint reader board:
1. Remove the two Phillips M2.0 × 2.0 screws (1) that secure the fingerprint reader bracket to the
computer, and then remove the bracket (2).
2. Disconnect the cable from the reverse ZIF connector on the fingerprint reader board (3).
3. Remove the fingerprint reader board from the computer (4).
Reverse this procedure to install the fingerprint reader assembly.
36 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
Bottom cover on page
Battery on page 31).
29).
29).
Spare part number
L70757-001