Husqvarna 535iRXT Workshop Manual page 15

6. Connect the cable (D) and the strain relief (E).
7. Install the wear guard. Refer to
guard from the battery housing on page 22 .
8. Connect the product to the common service tool
(CST) and do an update of the firmware if the control
unit is replaced. Refer to
service tool (CST) on page 10 .
5.2.3 Motor
5.2.3.1 To remove the motor (535iFR)
1. Remove the wear guard below the battery housing.
Refer to To remove the wear guard from the battery
housing on page 22 .
2. Remove the control unit. Refer to
control unit on page 13 .
3. Disassemble the battery housing. Refer to
disassemble the battery housing on page 22 .
4. Remove the harness loop.
835 - 004 - 25.10.2019
E
D
To remove the wear
To connect the common
To remove the
To
5. Remove the 8 screws and the cover.
6. Remove the 2 screws and the shaft.
7. Remove the 3 screws and the motor.
Repair instructions - 15