Henny Penny Velocity Series Service Manual page 14

Menu
Item
(Mod-
e)
T-21
T-22
T-23
T-24
T-25
T-26
T-27
T-28
T-29
T-30
4
Display
SEL VALVE PORTS
PUMPS
OPS/QPM SYSTEM
ENABLED?
RADIO COM (Zigbee)
ANALOG CHANNELS
HEAT CTRL
ALLOW LID OPEN
LID LINER PIN -MUST-
ACTUATE
AFTER COOK, PRES-
SURE STUCK ON
GIVES ERROR
AUTO-CYCLE PRES-
SURE SOLENOID?
Function
999. When running, top line shows time of each
revolution.
This section tests the positioning of each port on the
selector valve. P0 - At pot. P1 - At dispose (rear dis-
pose) P2- At FDI (front dispose) Enc - Encoder posi-
tion. FAIL - Selector valve does not function properly.
Press the illuminated button next to the function to start
test * - On - - Off Fltr - Filter pump ATO- JIB pump (op-
tional) Drn C - Drain valve (c - closed, o - open)
This section shows if the unit is equipped with a radio
system. To change the option press the plus or minus
button to select YES or NO
If the control is equipped with an OPS/QPM ZigBee
radio module, and it has been enabled (step T-23 or
SP-4), this test mode displays information received
from the radio module via the wired connection. If the
OPS System is disabled (see previous step), this step
simply displays ZigBee IS -OFF-
This test mode is available to display the current low-
level analog status of any of the analog inputs on the
primary Analog to Digital converter chip inside the
control.
This test mode has very specialized and very limited
use. It displays information about the heating algorithm
and its performance, and can be useful when tuning
the heating algorithm for a brand new fryer type.
Specifies the pressure reading above which control
displays WAIT at the end of the cook cycle - waiting for
the pressure to bleed down before beeping and dis-
playing Done
Specifies the pressure reading by which point the lid
liner pressure pin monitoring switch must actuate.
Specifies how long to wait at the end of the cook cycle
- i.e. when the cook timer has counted down to 0:00 -
before generating an E-86B error code if the pressure
hasn't bled down to a reasonable level so that the lid
can be opened.
Specifies whether or not the auto-cycle the pressure
solenoid feature is enabled. If enabled, a short time
after every cook cycle in which the pressure solenoid is