danalock V3 EURO Easy Install

Danalock V3 EURO Easy install for rosette doors
Tools needed
To mount the Danalock
you need a Philips
screwdriver and two
pliers or a wire cutter.
Parts involved on
your existing lock
Mortise plate
Lock screw
1. Remove the old cylinder
First you have to remove
your current cylinder.
Unscrew the lock-screw
in the mortise-plate on
the side of the door.
3. Adjust the new cylinder
Measure the back part
(on the outside of your
door) of the old cylinder
Outside
from the middle of the
screwhole and away
(see illustration).
In the Danalock box
you'll find an adjustable
lock cylinder.
4. Just unscrew
the small screws
on both sides of
the part you want
to remove, and pull
the cylinder apart.
5. Insert new brass tube and spacer piece
Remove too big
+7
spacer piece
and brass tube
+32
32
6. Assemble the cylinder and
screw the tiny screws back in
on both sides of the cylinder.
Contents of the
Danalock box
you'll need for
the easy install
Rosette plate
Cylinder
Back part
Inside
Measure from
center of screwhole
25
7
Please look at the size
guide to the right to find
the length for the spacer
piece and brass tube.
Adjustable
cylinder
Back plate Breakable screws
7. Size guide
When you remove one or
more parts of the cylinder
you'll have to exchange
the brass tube in the
center with another
that fits the new
measurements.
Here is the different
combinations.
Fits min. 50 mm
Fits min. 55 mm
Fits min. 60 mm
The adjustable
cylinder as it is
in the box
Rosette spacers
Tailpiece
adapter
Cylinder
brass tubes
2. Pull out the old cylinder
Insert your key and turn it so the
cam lines up with the body of
the cylinder. Then it will be easy
to pull out of the hole in the
rosette.
cam
Fits min. 35 mm
Fits min. 40 mm
7
7 space piece
Fits min. 45 mm
10
10 space piece
15
15 space piece
22
22 space piece
25
25 space piece
page 1/3
Small screwdriver
=
=
+7
=
+10
=
+15
=
+22
=
+25