danalock V3 Product Manual

Danalock V3 Product manual
The Danalock V3 Z-Wave is a secure electronic door lock that supports the Z-Wave Plus standard, which is
compatible with earlier versions of Z-Wave. The Danalock is battery supplied and therefore it is a FLIRS
Frequently Listening Routing Slave which conserves battery The Danalock V3 is a security enabled Z-Wave Plus
Product. A security enabled Z-Wave controller must be use. The Danalock V3 supports the standard security S0
and the new security standard S2. This manual covers all versions of Danalock V3 Z-Wave. This manual is
accompanied by the mounting manually for your specific lock.
Z-Wave interoperability
The Danalock can be included and operated in any Z-Wave network with other Z-Wave certified devices from
other manufacturers and/or other applications. All non-battery operated nodes within the network will act as
repeaters regardless of vendor to increase reliability of the network.
Z-Wave add/inclusion and remove/exclusion
• To add or include the Danalock into a Z-Wave network
1. Set the controller in inclusion mode
2. Push the switch once.
3. Wait 5 seconds.
• To remove or exclude the Danalock into a Z-Wave network
1. Set the controller in exclusion mode
2. Push the switch once.
3. Wait 5 seconds.
Factory Reset
The Danalock can be set to factory settings by pushing the switch ten times. Please use this procedure only
when the primary controller is missing or otherwise inoperable.
Batteries
The Danalock uses 4 CR123A batteries. Only use four new batteries
from the same manufacturer. Do not mix new and old batteries.
The Package contains
• Danalock V3
• Batteries (may not be included)
• Manual
• Adapters (may vary from country to country)
If the Danalock is firstly included on a Z-Wave network, the Bluetooth Smart is disabled because of security and
to conserve power. To enable Bluetooth Smart enable Configuration byte no. 5.
1 | P a g e