Chapter 4: System Configuration
Chapter 4: System Configuration
This chapter describes how to configure your StorEdge system by setting up the communication
between the system components and setting up the required a pplication. To use the StorEdge
applications, the inverter communication board firmware (CPU) version must be 3.xxxx and later. The
latest firmware version is available for download at http://solaredge.com/storedge/firmware.
Upgrading the Inverter Firmware Version
Upgrade the inverter firmware using a MicroSD card with the latest firmware version downloaded from
the above link .
To upgrade the inverter firmware:
1. Make sure that:
The inverter has been activated using the activation card supplied with the inverter
l
The inverter ON/OFF switch is OFF
l
The AC voltage to the inverter is OFF
l
2. Remove the inverter cover.
3. Insert the card into the communication board slot marked "CARD".
4. Turn ON the battery A UX switch and circuit breaker. Wait 1 minute before proceeding.
5. Turn ON:
AC to the StorEdge Interface
l
AC to the inverter
l
WARNING!
ELECTRICAL SHOCK HAZARD. Do not touch uninsulated wires when the cover is removed.
6. Turn ON AC to the inverter.
WARNING!
ELECTRICAL SHOCK HAZARD. Do not touch uninsulated wires when the cover is removed.
7. The upgrade starts automatically. Wait for the message Done to be displayed on the LCD.
8. Remove the card from the inverter.
20
Figure 21: Inserting the upgrade card
StorEdge Interface Installation Guide MAN-01-00380-1.1