Analog Outputs, Bipolar - X11 - Baldor MintDrive Installation Manual

3.2.4

Analog Outputs, Bipolar - X11

6
7
Two programmable analog outputs that can be used to provide real time status of various control
conditions. The voltage from the output buffer is supplied through a 50Ω resistor for short circuit
protection.
CAUTION:
32
Location Connector X11
Pins 6
Name AOUT2
Mint keyword AUXDAC.2
Description Two independent assignable outputs.
Output range: ±10VDC.
Resolution: 8-bit with sign.
Output current: 1mA maximum.
Update interval: 2ms.
X11
GND
1
Output 2
6
Output 3
7
Figure 13 - AOUT2 and AOUT3 analog outputs
Following power-up or a system reset, both outputs will initially be set at
approximately +10V. This condition will remain, for a short period, during the
software initialization process. For this reason, care should be taken if this output
is being used as a drive reference for a speed controller.
AOUT2
(AUXDAC.2)
AOUT3
(AUXDAC.3)
7
AOUT3
AUXDAC.3