Chapter 4 Display Programming - Garnet SeeLevel I 705 Series Manual

To program the LED brightness:
1. If the display is to be used inside the coach, the LED brightness should
be low. If it is to be used in the service bay area where sunlight can
reach it, the LED brightness should be high.
2. To program the LED brightness, the display needs to enter the
brightness programming mode. To do this, press and hold down the
BATT button, the display will show the battery voltage.
3. While continuing to hold down the BATT button, press and hold down the
GRAY button, do this for about 5 seconds until the display shows the
brightness programming mode. When this occurs release both buttons.
4. Press the GRAY tank button to increase brightness, or the FRESH tank
button to decrease brightness.
5. When the display shows the correct brightness, press the BATT button to
exit the programming mode.
To program the number of senders for each tank:
Note: for the 4 tank model, the grey and galley tanks can only have one
sender each, so for these tanks no programming is possible for the number of
senders.
1. To program the number of senders for each tank, the display needs to
enter the sender programming mode. This should only be done at the
time of installation, there is no reason to change the number of senders
afterward. Make sure that the number of senders programmed into the
CHAPTER 4
DISPLAY PROGRAMMING
100% 15V
75% 14V
50% 13V
25% 12V
0% 11V
Brightness programming