Garnet SeeLevel I 705 Series Manual page 19

the sender over the side of the tank and carefully stick it down. MAKE
SURE THAT THE END WITH WIRES IS POINTING UP!! Position the
bottom of the sender at least 1/4" above the bottom of the tank, and more if
required to equalize the space at the top and bottom of the tank. Make
sure that the sender is square with the tank. You only have one shot at
this, if you try to peel it off the tank once it is stuck the sender may be
damaged by the sharp bending. Carefully press the sender down to the
tank so that all of the adhesive is contacting the tank wall.
1-1/2 Inches
TOP OF SENDER
4-1/2 Inch
minimum
measurement
length
BOTTOM OF SENDER
SIGNAL
WIRE
Route wires to the right,
away from the sender
GROUND
WIRE