EMC Connectrix B Series Hardware Reference Manual page 29

Completing switch configuration
To complete the switch configuration:
1. Log on to the switch by telnet.
2. Modify the domain ID if required.
The default domain ID is 1. If the switch is not powered on until
after it is connected to the fabric and the default domain ID is
already in use, the domain ID for the new switch is automatically
reset to a unique value. If the switch is connected to the fabric
after is has been powered on and the default domain ID is already
in use, the fabric segments. To find the domain IDs that are
currently in use, run the fabricShow command on another switch
in the fabric.
a. Disable the switch by typing the switchDisable command.
b. Enter the configure command.
The command prompts display sequentially; enter a new
value or press Enter to accept each default value.
c. Enter y after the "Fabric parameters" prompt:
d. Fabric parameters (yes, y, no, n): [no] y
e. Enter a unique domain ID (such as the domain ID used by the
previous switch, if still available):
f. Domain: (1..239) [1] 3
g. Complete the remaining prompts or press Ctrl-D to accept the
remaining settings without completing all the prompts.
h. Reenable the switch by entering the switchEnable command.
3. Optionally, specify any custom status policies:
a. Enter the switchStatusPolicySet command at the prompt.
This command sets the policy parameters that determine
overall switch status.
b. Customize the status policies as desired.
To deactivate the alarm for a condition, type 0 at the prompt
for that condition.
4. Install the SFP transceivers in the Fibre Channel ports, as
required. The ports selected for use in trunking groups must meet
specific requirements. For a list of these requirements, refer to the
Fabric OS Administrator's Guide.
Installation and Configuration
Configuring the DS-5000B
29