Harmar Mobility AL010 Installation & Service Manual page 26

OUTSIDE VEHICLE LIFTS: SECTION 6
LIFT ADJUSTMENTS
Platform rail has
BATTERY TRAY
a slight lean back
so that the chair's
bottom battery
tray rests on the
platform pad.
Figure 6-17
2. If the chair's front caster frame contacts the
platform, or if the chair is leaning too far to the
passenger's side, remove one or two of the three
platform pads. Always re-attach the top pad with
a chamfer using the same screws. The platform
must have at least the top pad attached.
See Figures 6-18 and 6-19.
T o p P a d
Figure 6-18 and Figure 6-19
3. If the chair is leaning to far too the driver's side
of the vehicle, move the passenger side wheel
chock away to create a bigger opening.
See Figure 6-20.
Outside Vehicle Lifts:
26
06DEC19 | P/N: 630-00106 REV A
The ideal setup has the
front frame about 1/2"
above the platform rail.
Installation & Service Manual
1/2"
• Using a 3/16" hex drive and 7/16" wrench,
remove the bolt and nut from each side of
the platform. See Figure 6-21.
Using 3/16" Hex Drive and 7/16"
Wrench, remove bolt and nut
• Adjust platform as required.
• Use bolt to hold platform in place.
• Test platform with chair. Once satisfied,
fasten platform in place with nyloc nut.
See Figure 6-22.
Figure 6-20
from each side.
Figure 6-21
Figure 6-22
> 3/4"