Al030 Power Tote Installation With; Ball Mount Hitch Adapter - Harmar Mobility AL010 Installation & Service Manual

Swing-Away Adjustment Screw
If the model was purchased with a swing-away
option, read the following installation instructions.
Not needed for AL105L.
1. With the swing-away closed, loosen the nut.
2. Tighten the bolt so the ramp touches the pin in
the closed position.
3. Tighten the nut. Open and close the swing-
away. See Figure 4-15.
Figure 4-15
4. Verify the T-handle opens freely.
NOTE: There should be slight tension when pulling
the T-handle.
5. Verify the upper arm is locked and does not
move. See Figure 4-16.
Figure 4-16
Bolt
Pin
Nut
Ramp
Outside Vehicle Lifts:
OUTSIDE VEHICLE LIFTS: SECTION 4
AL030 POWER TOTE
INSTALLATION WITH BALL
MOUNT HITCH ADAPTOR
1. Install bumper mount of flat bar. See Figure 4-17.
FOR AL030 ONLY
Ball Mount Hitch Adaptor
Bumper Mount
Be sure to comply with
vehicle's bumper rating
Figure 4-17
2. Install hitch post assembly. See Figure 4-18.
Figure 4-18
WARNING
!
Do not use ball mount adaptor with swing-away.
Installation & Service Manual
06DEC19 | P/N: 630-00106 REV A
INSTALLATION
Flat Bar Style
OR
Be sure to comply with
vehicle's bumper rating
Omit
OR
Stabilizer
Flip Over
17