Table of Contents
Advertisement
Platform Assembly
1. Before attaching leg brackets to platform, determine the orientation of the
platform. Consider size, the direction of the non-skid, and leg location.
2. Install leg brackets with legs
to platform. Pull brackets up
before tightening the two bolts
with
nuts. Tighten one of
1/2"
two
bolts on each leg
9/16"
bracket with the leg slid down
to the appropriate height.
3. Confirm the height of the
platform is appropriate and then
level the platform using a 48"
bubble level. Always level up so that you do not change the overall height
of the platform. If platform is to be installed against an existing structure,
consider leaving platform a bit out of level for water runoff.
4. Tighten all
9/16
– there is no need to penetrate through the leg with the bolt. It is normal
for the bolt head to protrude out from the bracket.
5. Verify all hardware is tight.
04OCT19 | 630-00103-01 Rev B
bolts to lock the legs in place. The legs are held via pressure
8 |
P a g e
Advertisement
Table of Contents
