Post-Requisites - Alienware m17 P37E Service Manual

10 Connect the power-button board cable to the system board.
11 Place and align the USB Type-C port bracket on the palm-rest assembly.
12 Replace the two screws (M2x3) that secure the USB Type-C port bracket to the palm-rest assembly.
13 Connect the camera cable to the system board and adhere the tape that secures the camera cable to the system board.
14 Connect the coin-cell battery to the system board.
15 Connect the I/O-board cable to the system board and close the latch to secure the cable.
16 Adhere the tape that secures the I/O-board cable connector latch to the system board.

Post-requisites

1 Follow the procedure from step 2 to step 6 in
2 Replace the solid-state drive/Intel
3 Replace the wireless
4 Replace the memory
5 Follow the procedure from step 4 to step 6 in
6 Replace the battery (half-length)
7 Replace the base cover.
Optane.
card.
modules.
or the battery
Replacing the heat sink.
Replacing the hard drive.
(full-length), whichever applicable.
85