Building-In Your Oven - Panasonic NN-CD87KS Manual

Care of Your Oven
8. The roller ring and oven cavity floor
should be cleaned regularly to avoid
excessive noise. Simply wipe the
bottom surface of the oven with mild
detergent and hot water then dry with
a clean cloth. The roller ring may be
washed in mild soapy water.
Cooking vapours collect during
repeated use but in no way affects
the bottom surface or roller ring
wheels. After removing the roller ring
from the cavity floor for cleaning,
be sure to replace it in the proper
position.
9. When using the grill, convection or
combination mode, some foods may
inevitably splatter grease on to the
oven walls. If the oven is not cleaned
occasionally, it may start to "smoke"
during use.
10. A steam cleaner is not to be used for
cleaning.

Building-in Your Oven

1. In case of fitting into an oven
housing, please use Panasonic's
Trim Kit NN-TK81KCSCP-
Stainless.
2. Microwave ovens should not be
built into a unit directly above a
top front venting a conventional
cooker. This will invalidate your
one year guarantee.
50
11. This oven should only be serviced by
qualified personnel. For maintenance
and repair of the oven contact the
nearest authorised dealer.
12. Failure to maintain the oven in
a clean condition could lead to
deterioration of surfaces that could
affect the life of the appliance and
possibly result in a hazardous
situation.
13. Keep air vents clean at all times.
Check that no dust or other material
is blocking any of the air vents on
the top, bottom or rear of the oven. If
air vents become blocked this could
cause overheating which would
affect the operation of the oven
and possibly result in a hazardous
situation.
3. A microwave which is built in must
be more than 850 mm above floor
level. Read Trim- Kit instructions
carefully before installation.
It is recommended that the
microwave oven is placed below
a conventional oven to avoid
heat damage to the facia of the
microwave.