Installation And Connection; Placement Of Your Oven - Panasonic NN-CD87KS Manual

Installation and Connection

Examine your Oven
Unpack the oven, remove all packing
material, and examine the oven for any
damage such as dents, broken door
latches or cracks in the door. If you
find any damage, notify your dealer
immediately. Do not install a damaged
oven.
Earthing Instructions
If your AC outlet is not grounded, it
is the personal responsibility of the
customer to have it replaced with a
properly grounded wall socket.

Placement of Your Oven

This oven is intended for counter-top
use and built-in use. It is not intended
for use inside a cupboard. Refer to
Building-in Your Oven on page 50.
Countertop use:
1. Place the oven on a flat and stable
surface more than 85 cm above the
floor level, with rear of oven placed
against a back wall.
2. When this oven is installed, it should
be easy to isolate the appliance
from the electricity supply by pulling
out the plug or operating a circuit
breaker.
3. For proper operation, ensure a
sufficient air circulation for the oven.
a. Allow 5 cm at one side, the other
being open; 15 cm clear over
the top; 10 cm at the rear.
5 cm
8
15 cm
10 cm
Open
Important!
This unit has to be properly
earthed for personal safety.
Operation Voltage
The voltage has to be the same as
specified on the label on the oven. If a
higher voltage than specified is used, it
may cause a fire or other damages.
b. If one side of the oven is placed
flush to a wall, the other side or
top must not be blocked.
4. Do not place this oven near an
electric or gas cooker range.
5. The feet should not be removed.
6. This oven is only for household
usage. Do not use outdoors.
7. Avoid using the oven in high
humidity.
8. The power cord should not touch the
outside of the oven. Keep the cord
away from hot surfaces. Do not let
the cord hang over the edge of a
table or work top. Do not immerse
the cord, plug or oven in water.
9. Do not block the air vents on the
sides and back of the oven. If
these openings are blocked during
operation the oven may overheat. In
this case the oven is protected by a
thermal safety device and resumes
operation only after cooling down.