Table of Contents
Advertisement
4600 Series Flat Panel Industrial PC
4. Immediately apply electrical tape to the old battery on all sides in order to prevent
shorting the battery. The battery may still have charge and a short may cause fire or
explosion. Do not dispose of the battery with standard waste. Contact your local
waste disposal agency for the address of the nearest battery deposit site.
5. Install the new battery as indicated below. Note position of '+' sign.
TO RE-ASSEMBLE THE 4600 SERIES COMPUTER:
1. Install the rear chassis top cover (4612: four #6 screws, 4615: five #6 screws).
TO SETUP THE CMOS MEMORY:
1. Plug a QWERTY keyboard into the Keyboard port on the side of the 4600
series computer
2. Apply power to the 4600 series computer. The same ERROR and WARNING
messages should appear as before battery replacement. This is because the
CMOS memory must be setup:
ERROR
0271: Check Date and Time Settings
Warning
0251: System CMOS Checksum Bad – Default
Configuration Used
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
52
Chapter 4 – Maintenance
144732 (C)
Advertisement
Table of Contents
Need help?
Do you have a question about the 4600 Series and is the answer not in the manual?