Non-Routine - Eaton VoCALL 16 Installation And Operation Manual

n ote: The result of this weekly test, and the information of the outstation used,
should be recorded.
monthly check
Visual inspection of the battery and its connections should be made to ensure that it
is in good condition.
6 months inspection
An inspection must be conducted every 6 months by an 'ENGINEER' to thoroughly
inspect the system and ensure continued reliability.
1. Each outstation should be operated to check that the outstation is functioning,
and that speech is clear and intelligible.
2. A visual inspection should be made to check that all outstations remain
unobstructed and conspicuous.
3. Batteries and their connections should be examined, and load tested.
4. The functions of the Panel should be checked. All controls and visual
indicators at the panel should be checked for correct operation.
5. All fault indicators should be checked, where practicable, by simulation
of fault conditions.
Following modules can be self-tested under Test menu (Engineer access)
1. Keypad – All key press can be confirmed.
2. Buzzer – Self test tone is played for 4 seconds.
3. LEDs – All LEDs will glow one by one.
n ote: The result of this inspection and any outstanding defects should be reported
to the individual / organization responsible for routine maintenance and should
be recorded.
Remember to update the next 'Service date' for the system after the check.

16.3 Non-routine

From time to time, the VoCALL 16 EVC system may require non-routine attention,
including special maintenance. Non-routine maintenance includes:
1. A special inspection of an existing system when a new organization takes
over maintenance of the system.
2. Repair of faults or damage.
3. Modification to take account of extensions, alterations or changes
in occupancy.
4. Inspection and test of the system following a fire.
InStALLAtIon And opErAtIon mAnuAL 25-13741-E January 2020 www.eaton.com
16. Maintenance (As per BS 5839 – 9:2011)
91