Setup (Monitoring And Control); General; Local Mode Connection - Dekolink Deko2119 Product Manual

P M
RODUCT ANUAL

7. SETUP (MONITORING AND CONTROL)

7.1 G
ENERAL
This section provides the setup procedures for Mini-Repeater Deko2119.
The Mini-Repeater is set for plug and play operation, and usually this is
sufficient. However, you are probably required to set the channels (filters)
bandwidths. This requires setup procedures described in this section. These
procedures also provide the steps to obtain more information about the repeater
such as monitoring and parameters setting, as well as alarms.
The setup is performed in a local (defined as automatic in the software) mode
with the help of the RMS software installed on a host computer (usually, a
laptop).
7.2 L M
OCAL ODE
To set up a local connection (see Figure 9):
•
•
The RS-232 cable connector should be DB-9 pin type, pins 2,3 crossed, and
Figure 9: Mini-Repeater - Local Monitoring with Laptop
Page 20
M
INI
C
ONNECTION
Turn on the Repeater and wait for the three LEDs on the front panel to
turn on and show steady green
Connect an external serial cable from a PC (COM interface) to the
communications port in the bottom panel.
female-to-female terminated [supplied with the repeater].
-R D 2119
EPEATER EKO
Note
Proprietary Data
D W L
EKOLINK IRELESS TD
Pub. 313-2006 Rev. 2.01S
.