Dekolink Deko2119 Product Manual page 40

P M
RODUCT ANUAL
7.7.3 Channeler Area – Sub-Band (Filter) Selection
Mini-Repeater Deko2119 enables, by means of the SAW Switcher, to select
only one out three sub-bands of 5 MHz, 10 MHz or 15 MHz (see Figure 22).
In the current unit, the 5 MHz and 10 MHz channels are justapoxed, and
therefore you can select either one of them but not both.
Mini-Repeater Deko2119 enables to slide the selected channel along the
bandwidth range in order to set the selected frequency range. Proceed as
follows:
1. Determine the sub-band - 5 MHz, 10 MHz or 15 MHz by
clicking on the sub-band box to select it. If the sub-band is
out of bounds (therefore not shown), click on the arrow
buttons to bring it within the PCS band, then click on its box
to select it
2. Click on the selected sub-band and slide it until you position
it in the required range in the Mini-Repeater bandwidth. On
the other hand, you can use the arrow buttons for delicate or
fast sliding of the sub-band (see next paragraph).
Figure 22: Channeler Sub-Screen – Sub-Band Selection
Page 32
M -R D 2119
INI EPEATER EKO
N o t e
Proprietary Data
D W L
EKOLINK IRELESS TD
Pub. 313-2006 Rev. 2.01S
.