Installation And Operation; General; Safety Instructions; Installation Site Considerations - Dekolink Deko2119 Product Manual

P M
RODUCT ANUAL

4. INSTALLATION AND OPERATION

4.1 G
ENERAL
The small, lightweight Mini-Repeater Deko2119 is easy-to-install. Measurement
tools are most always never needed.
4.2 S I
AFETY NSTRUCTIONS
Before installing the Repeater, review the following safety information:
•
•
•
4.3 I
NSTALLATION
Mini-Repeater Deko2119 is provided with back panel flanges for easy
The
installation on any surface (see Figure 5). It is recommended to install the
Mini-Repeater on a flat rigid surface. The installation site for the Mini-Repeater
should take into consideration the following conditions:
•
•
4.4 T
OOLS AND
Measurement tools are most always never needed. No special tools are
necessary. However, a standard, professional, tool box is required for the

installation procedures.

4.5 I
NSTALLATION
The wall mount installation is the preferred method of installation for the
Repeater. Determine the location of the Repeater on the wall. The location
should be at normal eye level height, above ground.
Proceed as follows:
•
•
•
•
Page 12
M
INI
Follow all local safety regulations when installing the Repeater
Only qualified personnel are authorized to install and maintain the
Repeater
Follow Electro-Static Discharge (ESD) precautions.
S C
ITE ONSIDERATIONS
The Repeater should be installed in a ventilated and easy-to-reach area
The Repeater is convection cooled so the area should be unblocked to
ensure airflow.
M
ATERIALS
P
ROCEDURES
Mark the three drilling holes on the surface of the wall based on the
mounting holes on the Repeater chassis – see Figure 5
Drill the appropriate three (3) holes in the wall. Recommend the screw
sizes to use, such as: "It is recommended to use No. 8 screws".
Align the housing so that the mounting brackets fit into the holes in
the wall
Use hex-head screws or bolts, and washers to secure the enclosure
firmly to the wall. Recommend the screw sizes to use, such as: "It is
recommended to use No. 8 screws. The mounting screws should not
be smaller than no. 6."
Bolts and washers are not supplied with the Repeater
-R D 2119
EPEATER EKO
Note
Proprietary Data
D W L
EKOLINK IRELESS TD
Pub. 313-2006 Rev. 2.01S
.