Setup; General; Local Mode Connection - Dekolink DEKO2408 Product Manual

P M
RODUCT ANUAL

6. SETUP

6.1 G
ENERAL
This section provides the setup procedures for Mini-Repeaters Deko2408 and
Deko2409. Since both repeaters operate similarly, the following instructions
are provided once since the procedures are identical. Whenever necessary, the
differences are provided for each repeater.
The setup of Mini-Repeaters Deko2408 and Deko2409is performed in an
automatic (Local) mode with the help of the RMS software installed on a host
computer (usually, a laptop).
6.2 L M
OCAL ODE
To set up a local connection (see Figure 8):
•
•
The RS-232 cable connector should be DB-9 pin type, pins 2,3 crossed, and
Figure 8: Mini Repeater - Local Monitoring with Laptop
Page 18
M
INI
C
ONNECTION
Turn on the Repeater and wait for the three LEDs on
the front panel to turn on and show steady green
Connect an external serial cable from a PC (COM
interface) to the communications port in the bottom
panel.
female-to-female terminated.
R D 2408-09
EPEATER EKO
Note
Proprietary Data
D W L
EKOLINK IRELESS TD
Pub. 308-2005 Rev. 2.00S
.