Rf Exposure Warning - Dekolink Deko2119 Product Manual

D W
EKOLINK IRELESS
4.9.3 Additional Tool
In case the Mini-Repeater is connected locally to a laptop with the proper RMS
software (refer to Section 6), the Controls and Parameters screen includes a
Measurement window (see Figure 19).
You can check the FWD Downlink (dBm) value while relocating the Donor
antenna until you obtain a maximum input signal from the antenna.
4.10 RF E
XPOSURE
4.10.1 General
In order to finish the installation procedures, you must ensure that the
installation satisfies with the FCC RF exposure requirements and complies with
the following instructions.
4.10.2 Donor Antenna Exposure Warning
The Donor antenna should be connected to the BASE port in the Repeater with
a cable with typical 1~10 dB attenuation (in accordance with the length of the
cable). This antenna is installed outdoor and has very sharp beam (Yagi type or
panel) pointed to the BTS. This type of antenna has about 10 dBi gain.
The Donor antenna typical specifications are:
•
Gain:
•
VSWR:
•
Impedance:
The outdoor antenna must be installed to provide a minimum separation
distance of 30 cm (11.7 in.) from any personnel within the area.
4.10.3 Service Antenna Exposure Warning
The second antenna is connected to the MOBILE port in the Repeater via a
cable with typical 1~10 dB attenuation (in accordance with the length of the
cable). This type of antenna is omni (isotropic) or wide beam with 0 to 2 dBi
typical gain. This type of antenna is installed for distribution to different indoor
areas (in-building floors, tunnels, basements, parking lots, shopping centers
etc.).
The Service antenna typical specifications are:
•
Gain:
•
VSWR:
•
Impedance:
The Service antenna shall be installed to provide a minimum separation
distance of 20 cm (7.8 in.) from any personnel within the area.
Pub. 313-2006 Rev. 2.01S
L . M -R
TD INI
W
ARNING
8 dBd (-10.1 dBi)
Better than 1.5:1
50 Ohm
2 dBi
Better than 2:1
50 Ohm
Proprietary Data
D 2119
EPEATER EKO
P M
RODUCT ANUAL
Page 17