Dekolink Deko2119 Product Manual page 4

S W
AFETY ARNINGS AND
Throughout this manual, important safety warnings and admonishments are included to
warn of possible hazards to persons or equipment. A safety warning identifies a possible
hazard and then describes what may happen if the hazard is not avoided. The safety
warnings – in the form of Dangers, Warnings and Cautions must be followed at all times.
These warnings are flagged by the use of a warning icon, usually the triangular alert icon
seen below. The exclamation point within the triangular alert icon is intended to warn the
operator or service personnel of operation and maintenance from factors elating to the
product and its operating environment, which could pose a safety hazard.
G S W
ENERAL AFETY ARNINGS
Always observe standard safety precautions during installation, operation and
maintenance of this product. Only a qualified and authorized personnel should carry out
adjustment, maintenance or repairs to the components of this equipment.
This equipment is intended to be installed indoor. Wet conditions increase the
potential for receiving an electric shock when installing or using electrically
powered equipment. To prevent electrical shock when installing or modifying
the system power wiring, disconnect the wiring at the power source before
working with uninsulated wires or terminals.
Installation of an antenna must comply with the FCC RF exposure
requirements. See paragraph 4.9.
Page b
A
DMONISHMENTS
C U
ONCERNING SE OF
Danger: Electrical Shock
Caution: RF Exposure
Proprietary Data
T S
HIS YSTEM
Pub. 308-2005 Rev. 2.00S