Rms 650 Screens Operation - Dekolink Deko2119 Product Manual

D W
EKOLINK IRELESS
7.6 RMS 650 S
CREENS
7.6.1 General
This section provides the operation procedure of the RMS650 for setting and
monitoring Mini-Repeater Deko2119.
Operation of Mini-Repeater Deko2119 includes:
•
Setting the Controls and Parameters fields
•
Checking the Configuration data
•
Verifying the Alarms status
•
Verifying the operating parameters.
7.6.2 Setting the Controls and Parameters Fields
Proceed as follows:
1. Click on the Controls and Parameters tab (see Figure 16)
2. Check that the main operational boxes are on for proper operation
(see Figure 17)
3. Optional - Press the Get Parameters button to pull out the parameters
values from the Mini-Repeater (last setup values) – (see Figure 16)
4. Select and verify the values for the main parameters in the Link and
Smart ALC data fields (see Figure 17 to Figure 19)
5. Check the values of the measured parameters as shown in the
Measurement data fields, and determine the mode of selection for
Downlink amplification (see Figure 19)
6. Press the Send Parameters button to enter and save the selected
operational values in the Mini-Repeater
Whenever you select a new value, its display turns red until you finalize all
the procedures and the Mini-Repeater is set to the new values.
Pub. 313-2006 Rev. 2.01S
L . M -R
TD INI
O
PERATION
Proprietary Data
D 2119
EPEATER EKO
Note
P M
RODUCT ANUAL
Page 27