Operating Procedures - Dekolink Deko2119 Product Manual

D W
EKOLINK IRELESS
2. Connect the Service antenna cable to the MOBILE
connector
3. Verify that the DC power supply unit cable is connected to
the POWER connector.
The DC power supply unit is located at the top of the unit, behind the front
4.8 O P
PERATING
To operate the Mini-Repeater Deko2119, proceed as follows:
Do not operate the Repeater without terminating the antenna
The Block Selective Mini-Repeater is factory set to maximum gain and
1. Verify that the RF cables are connected to the proper BASE
and MOBILE connectors
2. Connect the AC connector of the DC power supply unit to
the Mains (110V/220 VAC). The Repeater is turned on
3. When the unit is powered on, the front panel shows the built-in test
procedures: the LEDs (DL, Power, UL) turn from Orange to Red to
Green (see Figure 6)
4. If all the functions operate properly, all three LEDs are green after the
initial test procedures are completed.
5. If your coverage design requires a total RF output power at maximum
traffic that is lower than the factory set maximum, insert a flat
screwdriver in the upper knob (Max Power - Selector) on the front panel
and set to the required output value.
Whenever the LEDs are lit differently, they indicate a malfunction. Refer to
Section 8 for troubleshooting.
Figure 6: Mini-Repeater – Indicators Panel
Pub. 313-2006 Rev. 2.01S
L . M -R
TD INI
panel (see Figure 1).
ROCEDURES
WARNING
connections with actual antennas or proper dummy loads.
maximum output power.
Maximum power consumption: 35W.
Proprietary Data
D 2119
EPEATER EKO
Note
Note
Note
P M
RODUCT ANUAL
Page 15