Technician Menus; Maintenance Menu - All Models Except Style 7D-7E-10D-10Sd - Bodet 5 Installation And Operation Manual

VII

– Technician Menus

To access the maintenance menu, open the configuration menu by pressing and holding "S" then
"+" for 3 seconds. Release both keys, then press and hold "S", then "+" again for 7 seconds.
7.1 Maintenance menu – all models except Style 7D-7E-10D-10SD
S
+
S
+ Hold down for 3 seconds
Open the « Configuration »menu
+ +
S
S
+ Hold down for 7 seconds
Software version
S
+
S
+
« nor » mode:
- If the clock is not configured the message « no Id » is displayed.
S
- If the clock is configured, the Wi-Fi reception level is displayed:
from 1 to 3:
(horizontal bars)
« Init » mode:
Out of the factory the clock behaves as an Access Point.
Once the clock is configured, the clock access pont is deactivated.
It can be activated again by selecting « Init ».
To exit the « Init » mode and deactivate the Access Point select « nor ».
In the « Init » mode pressing « S » exit the technician menu and display the time.
+
Set the T° offset. Accessible only if T° probe is connected
S
+
S
+
S
Display test (tests for correct functioning of all LEDs)
S
End of menu
Select synchronisation mode: NTP or independent NTP
+
(ntPI = The clock continues to work on its internal quartz.)
+
or
S
+
+ +
Resetting the clock (enabled when "rstY" is selected)
Restore to factory settings (enabled when "dF Y" is selected)
if the Wi-Fi signal is absent
S
Exit to T°offset adjustment or Clock restart
+
+
EN
+
+
. . .
17