Dismantling The Throttle Control Lock, Throttle Control And Spring; Cleaning And Inspection - Husqvarna 555 XP Workshop Manual

Safety equipment
6.9 Dismantling the throttle control
lock, throttle control and spring
1
Loosen the screw on the rear handle. Remove the
handle insert (A). See figure 19.
2
Loosen the throttle control lock (B) as shown in the
figure using a screwdriver or similar tool. Remove it
then from the shaft in the handle. See figure 20.
3
Press out the throttle control pin (C) with the help
of a punch. See figure 21.
4
Loosen the throttle cable (D) and lift out the throttle
control and the spring. See figure 22.
5

Cleaning and inspection

• Carefully clean and check all parts. See figure
13. Parts must be replaced if cracked or show
signs of other defects. Always use original
spare parts.
Check that the spring is intact and retains all its
•
tension.
22
- English
A
Fig 19
Fig 20
Fig 21
Fig 22
Fig 23