Table of Contents
Advertisement
Available languages
Available languages
Operation
Turn on the water supply.
¨
Switch on the electrical supply.
¨
Turn the temperature control knob to "MAX" position, the power indicator
¨
(red) will turn on, hot water will flow out within a few seconds. The more
temperature control knob being turned in clockwise direction, the hotter is
the shower.
The shower might not be hot enough even at the "MAX" position if
¨
incoming water supply from the mains is too cold or the pressure of water
is too high. In this case, you may adjust the stop valve to reduce the water
inflow in order to get the desired showering temperature.
NOTICE: It is unnecessary to turn the temperature control knob to "OFF"
position when the heater is not in use.
Switch off the electricity supply after shower.
¨
Maintenance
Please carefully read the section "Safety Information" first.
Test the ELCB regularly (at least once a month). Turn on the electricity and
¨
water supply, both red (POWER) and green (ELCB) indicators will light up
when turning the temperature control knob clockwise. Press the ELCB Test
button, both POWER and ELCB indicators should go off. Press the reset
button to resume the electricity supply.
If the Power indicator does not go off when you press the ELCB test button,
¨
immediately turn off the water supply, turn the unit off, and then switch off
the mains supply and contact Call Centre for repair service. Special skill is
required for repairing. Never try to repair the unit by yourself.
CAUTION: Risk of product damage. Do not use thinner, alcohol, petrol
or any other organic solutions to clean the unit. Use only damped cloth
with mild detergent.
1287791-X2-C
12
Kohler Co.
Advertisement
Table of Contents
