Table of Contents
Advertisement
11. Confirm Proper Operation
For All Installations
·
Power On/Off
- Turns the blower motor on and off.
Symbols illuminated in blue indicate available
modes/features. Modes which are operating will
display in green.
·
Activate Button
- Press OK to activate the
desired mode. The active mode will flash (green).
·
Up Arrow
- Increases the air flow when the air flow
mode is active. Increases the pulse speed when the
surge mode is active.
·
Down Arrow
- Decreases the air flow when the air
flow mode is active. Decreases the pulse speed
when the surge mode is active.
·
Outer Ring
- Rotate the outer ring to the desired
mode. The selected mode will flash (blue).
·
Indicator Bar
- Shows the air flow volume when
operating in the air flow mode. Shows the surge
speed when operating in the surge mode.
·
Purge Mode
- Select to initiate the purge mode
manually. The purge cycle will not start if there is
water in the bath. The purge mode blows any
residual water out of the air channels. The blower
motor starts and runs at a low speed for about two
minutes. An automatic purge cycle occurs when the
bath is drained and the water level falls below the
level sensors.
·
Air Flow Mode
- In this mode, air flow is directed
through any combination of the airjets in the
selected zones. Air flow can be adjusted with the
arrow buttons. When the surge mode is selected,
the air flow mode stops. When the air flow mode is
selected while operating in the surge mode, the
surge mode stops.
·
Zone 1
- This mode is used to select or deselect the
air flow through Zone 1.
·
Zone 2
- This mode is used to select or deselect the
air flow through Zone 2.
·
Zone 3
- This mode is used to select or deselect the
air flow through Zone 3.
·
Surge Mode
- When active, the air flow ramps up
from minimum to maximum and then down again to
minimum. The surge speed is adjustable between
approximately 10 seconds to 60 seconds by using
the up or down buttons. The up and down arrow
buttons can be used to adjust the surge speed.
Zones can be selected or deselected when in the
surge mode.
·
Chromatherapy Cycle (if provided)
Chromatherapy lights will automatically and
continuously cycle through the eight colors; white,
violet, indigo blue, aqua blue, green, yellow, orange
and red. One cycle through all eight colors takes
approximately one minute.
·
Chromatherapy Specific-Color (if provided)
When this mode is selected, you may choose a
specific color for the bath.
1070462-T01-B
''
''
-
-
11.
·
/
-
·
·
·
·
·
·
2
·
·
1
·
2
·
3
·
·
8
·
-14-
/
OK
1
2
3
10
8
1
-
60
Advertisement
Table of Contents
