All the information in this guide is based upon the latest product information available at the time of publication. At Kohler Company, we strive to fulfill our mission of improving the level of gracious living for each person who is touched by our products and services.
¨ Do not allow the children use this product alone. ¨ NOTE: When removing the unit from package, a small amount of water may be found inside. This is normal as the unit is tested during manufacturing process. Kohler Co. 1287791-X2-C...
ELCB is in normal condition. Increase water temperature by turning the Temperature Control Knob temperature control knob clockwise to “MAX” position. Decrease water temperature and turn off the heater by turning the temperature control knob counterclockwise to “OFF” position. 1287791-X2-C Kohler Co.
Fixture dimensions are nominal and conform to tolerances established by ¨ Standards TIS. Electrical Diagram 2P Mechanical ELCB Display 30A/40A Board 15mA, <0.1s Thermostat (double action) Voltage ~ 220V 50/60 Hz TRIAC Main Board PCB Flow Switch Heater Elements Kohler Co. 1287791-X2-C...
Page 6
Recommended galvanize pipe, stainless pipe, steel pipe, PVC pipe or special pipe for hot water. Installed underside of the lavatory. Cold Cold Cold Installed inside shower room and outer bathroom. Cold Cold Cold Installed with Bathtub. Cold Cold 1287791-X2-C Kohler Co.
Roughing-In Dimensions are approximate. Finished Wall Unit: mm Mounting Hole A KOHLER COMPANY Mounting Hole G1/2" Installation Select a suitable position in the bathroom. ¨ Remove the screw at the bottom of the unit. ¨ Remove the front cover from the bottom and then lift up the front cover.
At the same time fill up the heater tank. The heater tank must be filled up with water before turning on the electricity supply to prevent any dry burnt damage to the heating element. 1287791-X2-C Kohler Co.
Cut a small groove on the rubber seal “A“ (at the back of heater base) with ¨ a cutter for cable inserting. Kohler Co. 1287791-X2-C...
Page 10
VR shaft. (at the front cover). Press the upper part of the front of cover until it locks. Ensure the temperature ¨ control knob fix properly and screw the front cover to the heater base. This position This position 1287791-X2-C Kohler Co.
Page 11
Pull down the “RESET” lever, the heater unit should resume normal function, ¨ the green indicator should light on. If procedures stated above prevailed, the ELCB is functioning in normal condition. Switch off the electricity supply. ¨ Kohler Co. 1287791-X2-C...
Never try to repair the unit by yourself. CAUTION: Risk of product damage. Do not use thinner, alcohol, petrol or any other organic solutions to clean the unit. Use only damped cloth with mild detergent. 1287791-X2-C Kohler Co.
C. Temperature control C. Turn the temperature knob is set too high. control knob counter- clockwise until a cooler temperature is achieved. D. The thermostat is faulty D. Replace. or damaged. Kohler Co. 1287791-X2-C...